Crew Cab Wiring Info

Mod-Info
Home

YEAR: 2001 MAKE: Chevrolet MODEL: S-10 Pickup STYLE:

| ITEM | WIRE COLOR |POL | WIRE LOCATION |
| 12V |red | + |ignition harness |
| STARTER |yellow | + |ignition harness |
| IGNITION |pink | + |ignition harness |
| SECOND IGNITION |white | + |ignition harness |
| ACCESSORY |orange | + |ignition harness |
| POWER LOCK |lt. blue | + |brown plug at BCM *1 |
| POWER UNLOCK |white | + |brown plug at BCM *1 |
| LOCK MOTOR |gray | |drivers kick panel |
| UNLOCK MOTOR |tan | |drivers kick panel |
| DISARM DEFEAT |tan | |passengers kick panel |
| PARKING LIGHTS + |brown | |lt. blue plug at BCM *1 |
| PARKING LIGHTS - |white *4 | |lt. blue plug at BCM *1 |
| HEADLIGHTS |purple/white | - |purple plug at BCM *1 |
| DOOR TRIGGER |*2 | - |BCM *1 |
| TRUNK/HATCH PIN |pink/black | - |lt. blue plug at BCM *1 |
| TRUNK/HATCH RELEASE |black | - |purple plug at BCM *1 |
|FACTORY ALARM DISARM |lt.green | - |purple plug at BCM *1 |
| TACHOMETER |white | |PCM *3 |
| BRAKE WIRE |white | + |steering column |
| HORN TRIGGER |black | - |steering column *5 |


NOTES:
NOTE: This vehicle has the passlock II immobilizer system that, when
adding a remote start, must be interfaced with. Use DEI part 555t or 555L.
*1 The BCM is located to the right of the accelerator pedal below the
radio. The plugs on the BCM face towards the drivers side.
*2 Use tan for the drivers door located in pin B4 of the purple plug,
orange for the passenger door located in pin B2 of the purple plug, must
diode isolate these wires.
*3 The PCM is located on the passenger fender. On the 2.2L the wire is in
a black 80 pin plug pin 10, and on the 4.3L the wire is in a red 32 pin
plug pin 20.
*4 This wire will not test when using the headlight switch. This wire is
triggered by the DRL system. To meter the wire, start the car with the
parking brake set, when the brake is released this wire will go to ground.
*5 Also found in the brown plug at the BCM on vehicles with a factory
alarm.


(c) 1994-2002 Directed Electronics, Inc. All Rights Reserved

IMPORTANT: This wiring information is being provided free of charge on
an "AS IS" basis, without any representation or warranty. It is your
responsibility to verify any circuit before interfacing with it using
a digital multimeter. Directed Electronics, Inc. assumes no responsibility
with regards to the accuracy or currency of this information. Proper
installation in every case is and remains the responsibility of the
installer. DEI assumes no liability or responsibility resulting from an
improper installation, even in reliance upon this information